2006/42/EG Machine Directive Quality Systems

Benefit from Simplified Certification

Do you manufacture industrial machines listed under Annex IV of the machinery directive? If so, then you could benefit from the reformed guidelines. Auditing and certification of your quality assurance system by our experts will, in future, replace the CE mark. With this alternative conformity evaluation procedure, you not only stand to save time and money but can also guarantee the highest level of quality.

Benefits at a Glance

With certification of your quality assurance system by TÜV Rheinland you can:

  • Guarantee comprehensive quality assurance of your industrial machines
  • Prove that you are actively aware of the necessity to prevent accidents
  • Improve your market position with speedier product introduction
  • Document implementation of legal requirements with audit reports and certificates
  • Benefit from short audit times and our extensive experience

Applying the new Machinery Directive

The following industrial machines can be certified with the simplified conformity evaluation procedure:

  • Machines
  • Adaptable equipment
  • Load carrying devices
  • Chains, ropes, and belts
  • Detachable drive lines
  • Incomplete machines, such as gear systems

Two Steps to Certification of your Quality Assurance System

1. Preliminary Audit (optional)

Our employees will inspect whether your company's systems conform with the conformity evaluation procedure in an optional preliminary audit.

2. Complete Conformity Evaluation Procedure, Annex X Audit and Certification

According to annex X, your company requires a quality assurance system for machine production in the following areas:

  • Development
  • Manufacture
  • Final inspection
  • Audit

As an appointed body, we will carry out a survey of your quality assurance system. It has to warrant that your machines cohere with the basic requirements of the directive, particularly in the fields of safety and ergonomics.

The New 2006/42/EG Machinery Directive (Annex X)

The recently reformed 2006/42/EG machinery directive (annex X) states the following: besides numerous technical changes for manufacturers of annex IV products, there is now an alternative procedure for conformity evaluation. The time- and cost-intensive prototype audit required for all annex IV listed products is no longer necessary. As of now, you can authorize TÜV Rheinland, an appointed testing institute, to issue the CE Mark following careful audit and documentation. The prerequisite for this is a certified, comprehensive quality assurance system that concurs with annex X of the directive. Issuing of the annex X certificate has been possible since December 29, 2009.